Search Our Products

Browse Products

Technical Information

X1663BT (X1663BT)

Customize Your Product:

Fender Flare Trim mounts between the fender flare and the body.  Made of an ozone resistant EPDM dense rubber, our trim is flexible and fits most any fender flare. A 3M automotive grade peel-n-stick tape creates a solid bond between both surfaces.

Trim-Lok Fender Flare Trim is easily attached before the fender flare is installed against the body of the car or truck.  Whether you need to replace your worn out fender flare molding or you're replacing your fender flares, fender edge trimming helps the fender flare fit tightly against the vehicle body to minimize vibration, minimize gaps and provide an attractive finish.

X1663BT *
Optional Customer Part Number
  • Buy 2 or more and pay $301.50 each (save $36.50 each)
  • Buy 10 or more and pay $273.00 each (save $65.00 each)

*Price breaks, where applicable, will be reflected in cart*


For volume pricing above 5,000 feet, please contact Trim-Lok at 888-874-6565

Price: $338.00
Description Rubber Seals come in a variety of specially designed shapes made
from custom formulated EPDM sponge rubber compound.
Resistance to
  • Ozone – Excellent
  • Water Absorption - Excellent
  • Sunlight Aging - Excellent
  • Low Temperature – Excellent
  • Compression Set - Good
General Temp. Rating -20 Degrees to +158 Degrees
Compression Rating Recommended 25% compression for the maximum performance.
Flammability and Code Compliance FMVSS 302 (Right Click and Select Save As)
UL50 (Right Click and Select Save As)
This (component or material) is Recognized by UL. Representative samples of this component have been evaluated by UL and meet applicable UL requirements.
Adhesive Options
  • "BT" Pressure Sensitive Adhesive This 3M Acrylic Automotive grade tape creates the ultimate bond to the rubber and the ultimate bond to the substrate. Creates a moisture barrier and airtight seal
    between rubber and substrate. Highest peel and shear resistance can be used under high loads of stress and force. Has low initial tack for easy re-positioning during installation and needs 72 hours of
    cure time to come to full bond strength. Good heat performance -20F to +158F.
  • "HT" Pressure Sensitive Adhesive This acrylic based adhesive is best used to hold the rubber seal in place while installing it in a static application or compressed between two stationary objects. May be used in some light duty dynamic applications against a variety of substrates. Good heat performance - 20F to +158F. Please note during application ambient temperature must be above +60F.
Rubber Seal Spec Sheet (Click to Open)

To view our entire catalog of products, download a copy or request a FREE copy be mailed to you, please click here:  CATALOG

Rubber Seal D Profiles

Rubber Seal D Profiles

Rubber Seal D Profiles

Rubber Seal Triangle Pedestal

Rubber Seal P Profile Lid Fender

Rubber Seal Ribbed Flap

Rubber Seal Tubing Cord